Sand the finish lightly with 220-grit sandpaper wipe off the sanding dust with a rag and spray a full wet coat. Soak a clean soft rag in mineral spirits.
I oversprayed Lysol on my wood table and formed white cloudy spots.
How do you fix a cloudy wood table. The trick is to turn the steam on. Do not place the iron on the table for a long time as you can end up damaging the furniture. Let it sit for close to a minute and check to see if it helps to remove the stain.
Do not use gel toothpaste for this. All you need is an iron A simple way to handle light watermarks is to expose it to gentle heat and pressure. Rub gently over the stain until the paste feels warm.
Wipe the cloudy area with the cloth using long. Although that is probably all my tables needed I decided to go all out and do the heavy on my tables by taking them back to the bare wood so I did 3 coats. Murphys oil works instantly.
If the water stain has been there for only a few days use the heat in this method to evaporate all. If you are worried about the heat worsening the stain you can slowly move the iron around the spot area or even hover the iron and let the steam fall directly on the spot. Iron water stains out of wood tables.
Heres a method to try on lacquered wooden surfaces only. Removing the cloudy layer of wax and replacing it with a fresh layer will get your table shining again. Lightly sand the piece with 220-grit sandpaper if cloudiness persists.
Keet reapplying the hot iron turn the steam onthats watch the magic happen. When the coat dries the blushing should be gone. With the iron set.
Mix 5050 toothpaste and baking soda rub in. Iron the cloth allowing for several sweeps and passes with the iron. Wipe any residue moisture left on the table.
If it isnt add a retarder to the. For this youll need an electric iron and a plain non-abrasive cloth. If it is lessening and there is no damage to the surface of the wood continue ironing the linen cloth on top of the wood until you have covered the entire surface of the dining room table.
34 coats should be about right for bare wood 1 or 2 for lighter work. Taking an old iron set to high dry heat place it on top of the towel directly over the stain. Check underneath the linen cloth.
Mix a dab of non-gel toothpaste with baking soda to make a paste. Apply the solution to the wood surface using your brush. If the entire surface is cloudy start bushing in the center of the area and move your strokes to the outside of the wood.
Sand until the polyurethane finish is removed. If you are only doing light maintenance 1 coat should be sufficient. The white marks will literally disappeared from the table.
Notice the cloudy buildup condition. I took the Murphys poured a nickel size amount on a cleaning towel and circularly rubbed each area. As with most stains it helps to act quickly.
Rub in a paste of salt and olive oil allow to sit for up to an hour. Only apply a thin coat of the solution to the area with the cloudiness. Reapply the finish per label directions stirring the product as you work.
How To Remove White Heat Stains From A Wooden Table Top Youtube