And quick too BUTbefore we get started on the makeover let me show you how this furniture looked when it was new. With the tabletop and chair seats ready to go it was time to apply the grey wood stain.
Sand very lightly with 220 grit sandpaper to remove any slight bumps in the finish.
How to refinish a wood table with stain. Let the first coat dry at least four hours. Once most of the stain is removed feel the wood and notice the rougher texture. Then you can move on and put on the clear coat.
This allowed me to stain the sides and the small overhang underneath at the same time as the rest of the table. Spray with a nice even motion following the natural lines of the piece. Wipe down the surface with mineral spirits.
To do this you need to remove all traces of the previous stain and smooth out the damaged surface with a sander. Apply stain with a disposable brush following the woods natural grain. Use 220-grit sandpaper and go over the table top moving back and forth in the same direction as the wood grain until the entire surface is smooth to the touch.
Apply it with a paintbrush. Solid wood is a better candidate for refinishing than veneer which tends to be thinner. Spray-on clear coat is easy to use and provides great coverage.
Yall this Mohawk Wiping Wood Stain is AH-MAZING. If you decide your wood table need the extra protection remember to allow the stain to dry to avoid chipping peeling or loss of color. Let the stain soak into the wood for just a few minutes before wiping it off with a clean towel.
How To Refinish Outdoor Wood Furniture with stain so easy And it was easy yall. 6 Finally it was time to stain. A single coat does the job and once it dries youre ready to stain.
Apply stain liberally allowing it to soak in for a few minutes then wipe off excess stain with a soft cotton rag synthetic rags arent going to soak up excess stain using the rag to rub the stain into fine cracks in the wood. 5 I used the Wax Wash Remover to clean the table one more time before I moved on to staining. I propped up both sides of the table with bench cookies.
Apply the stain with a brush or a rag and use a separate rag to wipe off excess before it dries. Reapply the stain to reach the desired depth of color. Once your last coat of stain is totally dry apply an oil-based clear coat for a final layer of sheen and protection.
And for that matter dont attempt to refinish laminate eitherits plastic people. How to Refinish a Table By Sanding Start with Low Grit Sandpaper The key to getting good color and coverage with the new stain is to get down to the raw wood. Apply polyurethane cover for shine and protection We used polyurethane cover for protection since this repurposed wood table will be in the patio.
Youll find wood conditioner at any paint supply store because its a common thing to use when you refinish furniture. Then apply the new finish by applying a coat of stain. As you can see in the photo I did have a crack in the piece of wood on the bench back so glued and clamped it before staining.
Spread out the stain as you work so that you get a evenly covered surface. Your not sanding any of the stain off if their are darker areas build them up with more pickling stain. Its very very thin so take care when working with it because it does splatter easily.
To refinish a wood table start by coating the table in stripper waiting 15-20 minutes and using a plastic scraper to take the paint or varnish off. When youre done stripping the table sand the surface in the direction of the grain to even out any discoloration or irregularities. Brush the stain liberally onto the table following the natural direction of the grain.
Let the table dry according to the directions on the stains packaging. Apply the stain to the table top in hundreds of short very light feathery strokes Dont wipe the stain off.